First thing i did is to check on any possible leakage from the newly bought 2 feet aquarium.
Then, i fit all of the components inside it to get more accurate looks and measurements.
I started Tinting the Rear and each side of the glass.
Now is the time for the installation of the 3M RGB LED.
Measured it, connect every part of it, cable sleeved it, and then attached it in the case.
And this is where i attached the LCD for the temperature sensor from previous case.
"Finale"
About
This page was stale. It has officially been made unstale now. You're viewing version 2.013. Aren't you lucky?
I'm Rauzan. I love Custom PC and will only blog about them this time.
Powered by Blogger.
Warning !!!
All activity in this blog might harm you. Do not follow without experienced adult supervision !!!
This blog also has extremely SHARP EDGES! Do not touch the edges of this blog.